Description

Attach the transfer securely to the Ceramic Mug using SDN Sublimation Heat Tape.
Cover the transfer with protective paper, making sure not to extend the paper excessively beyond the top and bottom of the mug.
Position the Ceramic Mug inside the Mug Press and securely close the heating element around the mug.
Apply medium pressure and set the temperature to 400°. Keep the mug pressed for 4 minutes and 30 seconds.
Use a soft wet cloth or a dish sponge to remove any remaining paper residue.

Step-by-Step Instructions for Operating an Oven:

Begin by preheating the oven to a temperature of 400 degrees Fahrenheit.
Cut out the provided template and securely attach it to your mug using tape, ensuring a tight fit. (Optional: If you intend to add a handle design, ensure it is firmly taped down.)
Create a small slit approximately 2 inches from the bottom of the shrink wrap. Slide the wrap over the mug, making sure the handle is positioned outside.
To prevent any separation during the heating process, tape either the mug or the shrink wrap under the handle securely.
Tuck any excess shrink wrap into the mug and evenly tighten the wrap by using a heat gun to apply hot air.
Place the mug with the shrink wrap in the preheated oven and allow it to bake for 13 minutes.
Exercise caution when removing the mug wrap and paper from the hot mug immediately after taking it out of the oven.
Allow the mug to cool by placing it under a fan or utilizing a Kool Plate.

Additional Items Required: SDN Heat Tape